This is a follow up to the “Entrance Door Project”. The customer requested glass sidelites with an etched fleur de leis. We decided on a slightly different approach for privacy. We applied a sandblast mask where the fleur de leis were located and proceeded to blast the surrounding area....
Uncategorized
BLACK WALNUT TABLE-PART FOUR
We completed the structural part of our table by fastening the substrate to the under side with 1 5/8″ wood screws. We reinforced the perimeter with an additional 2″ x 3/4″ plywood ring…notice the concentric circle pattern of screws on 6″ centers. We laminated an additional walnut ring 1...
BLACK WALNUT TABLE-PART THREE
We joined the 2 table halves with an ample amount of glue and biscuits, used the ratchet straps to secure until dry and mounted to the 3/4″ plywood substrate. We layed out the location of the starburst and perimeter ring in our Cad program. The pocket for our inlays will...
BLACK WALNUT TABLE-PART TWO
The next step in constructing our table involved creating a substrate to fasten our table top too. This is necessary to provide structural support for the 12 wedges. We decided that ¾” plywood would provide the support needed. We did the layout for the substrate in our cad program…we...
BLACK WALNUT TABLE-PART ONE
Our customer has requested a 72″ round black walnut dining table. The piece will have an 8 sided starburst in the center with a half inch ring just inside the perimeter. The inlayed starburst and ring will be of Gaboon ebony…an exotic wood from the Ivory Coast. The field...
ENTRANCE DOOR-PART TWO
We completed our door by assembling our components which consisted of 5” stiles and 6 ¾” rails. The components were run on various shapers with detail machining on our MultiCam 5000. The assembly is much the same as we covered in our “Gate Project”. After the detail machining and...
ENTRANCE DOOR-PART ONE
A customer has requested we build a custom entrance door for their new home. The complete unit will consist of 2-15″ sidelites and a 36″ door. The overall dimensions are 72″ in width & 90″ in height with a 6″ arched radius spanning the entire length. We will use...
ALLIGATOR TEXTURED GUITAR
Project produced with EnRoute Pro and CNC router by MultiCam. This is a project we did a while back; I think you will find it interesting. One of our customers has an alligator products business. This customer is also a musician with friends in the music industry. We were...
DE-NAILED PINE CORBELS
We made corbels today…these will provide support for the mantle in our earlier project. The dimensions for the 2 corbels are… 10 ¾” tall, 5 ½” wide with a depth of 8 ½”. The body of the corbels consist of 4 pieces…the 2 center pieces are 2” thick &...
DE-NAILED MANTLE
A customer requested we mill a de-nailed pine beam for use as a rustic fireplace mantle. The beam measurements were…length 108”, width 12” and a thickness of 6 ½”. The finished mantel would be…length 66”, width 11” and a thickness of 5 ¼”. We spent several hours removing...